Tidy Wiring, tidy mind.

With 6 sensors, an i2c multiplexer, pan-tilt HAT, a motor controller and motors to wire up and most of these components needing both power and data connections there's gonna be a heck a lot of wiring to lay throughout our robot chassis.

We needed a solution for tidy routing so we protoyped something using a scrap of plyboard and cable ties. It seems to work quite well. We'll just need to plan where to drill all the holes on our competition chassis. Something for early next week as we complete our build.

Yes... we are cutting this fine.

comments powered by Disqus